MEPCO Bill Calculator 2026 — Estimate Units & Taxes

What This MEPCO Bill Calculator Actually Does

The tool above estimates a MEPCO electricity bill before the paper bill arrives. You enter your units, or your current and previous meter readings, and it applies the NEPRA-approved slab rates for South Punjab as notified under SRO 279(I)/2026. The output is a full line-by-line breakdown — energy charges per slab, Fuel Price Adjustment, FC Surcharge, TR Surcharge, Electricity Duty, GST, and income tax where applicable — not just a single rupee figure.

Four inputs make the result close to your actual bill: units consumed, consumer category (Lifeline, Protected, Non-Protected, Commercial, Industrial B-1, or Agricultural Tube Well), filer or non-filer status, and the current month’s FPA. The advanced panel lets you override FPA, QTR, GST, and Electricity Duty if NEPRA issues a fresh notification between your visits.

How to Use It in Under a Minute

If you already know your monthly units, type them into the first tab and pick the right category. If you do not, switch to From meter reading and enter the current reading and the previous one — the tool subtracts them for you. Households unsure of their typical consumption can use the By appliance tab to build an estimate from ACs, fans, fridge, water motor, and other loads with their daily hours.

For households trying to stay inside a budget, the Reverse tab works the other way around: enter the amount you can afford and it returns the approximate units you can use this month at your current category and tariff.

Features Of Our MEPCO Bill Calculator

Most calculators on the SERP ask for units, return one number, and stop there. This one was built after testing every top-ranking tool and noting the gaps:

• Slab visualizer. A live bar shows how close you are to the next slab boundary, so the 200-unit cliff-edge becomes visible before it costs money.
• Slab-jump warning. If your usage sits within 25 units of a boundary, the tool flags it. Crossing 200 in any single month shifts the entire household to Non-Protected rates for the next six billing cycles.
• Filer / Non-Filer toggle. Income tax on residential bills over Rs 25,000 doubles for non-filers (15% vs 7.5%). No competitor includes this.
• Agricultural Tube Well and Industrial B-1 categories. Farmers and small-industry consumers across the MEPCO belt — Multan, Rahim Yar Khan, DG Khan, Vehari — were ignored by every existing calculator.
• FPA and QTR as editable inputs. FPA changes monthly. QTR applies only in March, June, September, and December. Hard-coded values mislead users; editable values stay honest.
• Auto-corrected category logic. Selecting Protected while entering 285 units triggers a correction instead of producing a wrong figure.
• Print or save the breakdown as a PDF for budget records or to compare against the paper bill when it arrives.

Where the Estimate Will Differ From Your Real Bill

No third-party calculator matches a MEPCO bill rupee for rupee. The gap comes from four places: the FPA notification for the exact billing month (set by NEPRA mid-month), the Quarterly Tariff Adjustment when it falls due, any deferred amount or arrears carried forward, and estimated meter readings on cycles when the meter reader did not physically visit.

Use the figure here for planning, budgeting, and catching obvious overbilling. For the official amount, check your MEPCO bill online with your 14-digit reference number.

Sources and Last Verified

Tariff rates reflect NEPRA’s consumer-end schedule for MEPCO under SRO 279(I)/2026 and the most recent monthly Fuel Charges Adjustment. FC Surcharge, GST, and Electricity Duty rates are set by the Federal Board of Revenue and the Government of Punjab respectively. Verified against NEPRA notifications and the MEPCO official tariff page in June 2026.